Danuser HP-3060 Hex - Manual (Page 9)

STEP 1: Attach drive unit (1) to the knuckle sub-assembly (2) using pin (3). Secure pin
(3) with klik pins (4).
STEP 2: Remove bucket from dipperstick and curl cylinder pin connections. The
dipperstick pin will be used to attach the knuckle assembly to the dipperstick.
The curl cylinder pin will not be required for drive unit installation.
STEP 3: Space the two ear assemblies (5) to the width of the dipperstick and secure
them to the knuckle sub-assembly (2) using tube-clamps (6), bolts (7), and nuts
(8). The ear assemblies should be spaced evenly from the center of the
knuckle sub-assembly and the safety signs should be facing out. Nuts (8)
must be torqued to 50 ft.-lbs. Nuts (8) should be checked and re-torqued after
the first hour of use.
STEP 4: Attach knuckle assembly/drive unit to the dipperstick using the dipperstick pin
removed from the bucket in STEP 2. Secure the bucket pin per vehicle
manufacturer’s recommendations.
Assembly
& Installation
TLB & Excavator Mount
9
Drive unit and auger
exploded views and part lists
are detailed on separate pages
in this manual.
Because of the weight of
some components, and
because some
components are difficult
to balance, two people are
required for safe
assembly and installation
of this equipment.
Personal protection
equipment including hard
hat, safety glasses, safety
shoes, and gloves are
recommended during
assembly, installation,
operation, maintenance,
removal, or movement of
the earth auger. Do not
allow long hair, loose
fitting clothing, or jewelry
to be around moving
parts.
REF. NO. PART NO. DESCRIPTION QTY.
1 ----- Drive Unit 1
2 10247 Knuckle Sub-Assembly 1
3 10032 Pin (1-1/4” x 7-5/8”) 1
4 1600 Klik Pin 2
5 ----- Ear Assembly 2
6 10242 Tube-Clamp 2
7 10243 Bolt (5/8” 11 x 2”) 4
8 3092 Nut (5/8” 11) 4
9 10038 Special Retaining Bolt 1
(3/4” 10 x 4”, Gr. 8, 3/4” of thread)
10 10041 Nut (3/4” 10) 1
= Safety Sign
Location
5
2
6
7
8
1
3
4
10
9