dB TECHNOLOGIES DVA NETWORK 1.2 Reference Manual - Manual (Page 6)

5/16
Rev 1.0
To add a speaker, first select the controller ID and the Line ID ( subnetwork number) where the device will
be added, and then double click on the speaker itself.
D
evices will be placed near the “next device here” cursor.
Normally, devices detected after a “Scan Device” operation will be automatically added in the synoptic
without using the “Add Object” function.
2.5 Devices Plugins
When a Device (e.g. DVA T12) is connected to
RDNet and correctly registered by the RDNet
software (or added by “Add Object“ function), it is
represented on the synoptic window by an object
like this:
A descriptive string appears in the left top angle to show the following informations:

Controller number (ex. 2)

sub-network (line) number (ex. 1);

device enumeration address (ex. 1). It is related to the physical connection order on the RDnet line.
First device connected will be enumerated as Device 1.

Group (ex. B). The “-“ symbol means that no group has been assigned to the device;

Model name (ex. DVAT12).
Below the descriptive string there is an area that contains:

Comm indicator (communication error) that becomes red if a communication error occurs;

Eq. Sync indicator: when gr een it indicates that the current device’s Group equalization is
synchronized between software and hardware; Yellow means OUT OF SYNC

Status indicator specifies the diffuser’s status; when red it indicates that the device is in FAULT
condition

MUTE button;

SOLO button;

Signal Leds: are located under the central image that graphically represents the device.
Leds show the audio signal status for each audio way (ex. LF, MF, and HF for DVA T12).