ECOXGEAR ECOXPRO - Manual

Waterproof Speaker Case (Model: GDI-EGPRO100/101/102/103/104/105/106/107/108/109/110)
Specifications
Frequency Range: 160Hz-20,000Hz
Output Power: 3 Watt
Power Source: 3 x AA-size batteries Battery Life: 30 + hours with alkaline batteries
Dimensions: 7.3” (L) x 4.7” (W) x 2.6” (H) Headset Jack: Waterproof 3.5mm headset jack
Weight: 1.06lb Floating payload (MP3 player, keys, documents etc) maximum: 8 ounces
Temperature (Operating): 23°F to 104°F IPX7 Waterproof Rating: water submersion not to exceed 3’ depth for 30 minutes
Temperature (Storage): 14°F to 131°F
FCC Compliance Statement & Warning:
This device has been tested & found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The device generates, uses & can radiate radio
frequency energy & if not installed & used in accordance with instructions may cause harmful interference to radio communications. There is no guarantee that interference will
not occur in a particular installation IF this device causes interference to radio or television reception try one of these measures: reorient or relocate the receiving antenna,
Increase separation between device & receiver, connect the device into an outlet on a circuit different from that to which the receiver is connected, consult a dealer or
experienced radio / TV technician for assistance. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the device and/or void the manufacturer’s limited warranty.
INTRODUCTION Thank you for your purchase of the ECOXPRO speaker case by ECOXGEAR. The ECOXPRO is a waterproof case with
a built-in amplified waterproof external speaker & waterproof 3.5mm earphone jack. The case will hold & protect your MP3 player, cell phone,
keys & other personal items from the elements.
Location of Controls
1) Power / Volume Knob: To optimize your speaker’s sound set your audio device’s volume (e.g. iPod, cell phone, MP3 player, etc.) to
approximately 75% of the maximum level. Rotate the ECOXPRO’s volume knob to the right to increase volume. To turn the unit ‘off’, turn
the knob to the left until a ‘click’ is felt & the LED above the volume knob turns ‘off’.
2) Power LED: The LED above the volume knob illuminates ‘on’ when the batteries are in use, even if you do not hear sound from the
speaker or connected headset. To optimize the lifespan of the batteries turn the ECOXPRO off when not listening to music.
Installing Batteries
1) Open the ECOXPRO & remove the battery door. The battery door is located on the inside
compartment of the ECOXPRO.
2) Insert (3) AA batteries in the battery compartment. Be sure the ‘+’ and ‘-‘ of the batteries
are inserted in the same orientation per the picture & markings shown to the right.
IMPORTANT: Use new, fully charged & commonly branded batteries. Improper batteries
may result in audio distortion or “hum” from the speaker
3) Replace the battery door.
Listening to your Music
1) Plug the ECOXPRO audio cable into the headset jack of your audio
device / source (e.g. MP3 player, iPod, iPhone, Smartphone, etc.)
2) BEFORE connecting your Smartphone device, use the SELECTOR
to set between 2 categories (I or S) of device connectors:
“ I ” includes: iPhone & iPod, HTC, Motorola, BlackBerry, LG, Palm
“ S ” includes: Samsung, Sony Ericsson, Nokia
NOTE: The slide switch is for selecting the ECOXPRO’s audio interface circuit to work best with either
of the two major classes of smartphones / audio devices. The iPhone position is for smartphones made
by Apple (iPhones and iPods), Blackberry, HTC, LG, Motorola and Palm. The Samsung position is
for those made by Samsung and Sony Ericsson, Nokia and other manufacturers.
3) Turn the volume on your audio source up to a normal listening level and choose ‘play’.
NOTE: for best sound turn the source volume up to approximately 75% of the maximum level. If the
volume on your audio source is too low, the volume level out of ECOXPRO speaker or headset may be
too low. If the volume level on your audio source is at 100%, the speaker audio may distort due to
excessive high volume level output.
4) Turn the volume on the ECOXPRO to the desired listening level over the speaker or connected
headset.
ECOXPRO
I: iPhone, HTC, Motorola,
Blackberry, LG, Palm
S: Samsung,
Sony Ericsson, Nokia
I
Selector
S
Waterproof 3.5mm Headset Jack
S I