Blaupunkt DX-R70 User Manual
Page 105
105
INTRODUCTION
NAVIGATION
RADIO MODE
CD MODE
INDEX
SETUP
CD CHANGER
ENGLISH
DEUTSCH
DEUTSCH
DEUTSCH
✔
You will be asked to drive the route.
7
Use the / buttons on the rocker switch
7
to select
START
.
8
Carry out the steps as instructed by the system.
Carrying out the system test
You have the option of carrying out a system test. The system checks the GPS
antenna and whether the reversing signal and the vehicle ignition are correctly
connected to the system.
1
Select
SYSTEM TEST
menu item in the
INSTALLATION
setup menu.
2
Press the OK button
8
.
3
Choose between
SENSOR TEST
,
INTERNAL
TEST
and
CALIBRAT. DATA
.
✔
The displays containing the corresponding test results are shown.
Activating / deactivating the code LED
You can activate the code LED to indicate that your TravelPilot is theft protec-
ted. The code LED is located on the ON button
2
. If
CODE-LED
is activated in
the setup menu, the ON button
2
flashes when the unit and vehicle ignition are
turned off.
To activate / deactivate the code LED,
1
select the
CODE-LED
menu item in the setup menu and
2
keep pressing the OK button
8
until the required
ON
or
OFF
setting is
displayed.
The code LED is activated / deactivated
SETTINGS
INSTALL
DEFAULT SET.
KEYCARD
FM-SEEK
SENS
CODE-LED
ON
INSTALLATION
SYSTEM TEST
CALIBRATION
GPS STATUS