Elkhart Brass Valve Motor Replacement Kit P/N 81302001 User Manual

Elkhart Brass Equipment

Advertising
background image

98255000 Rev-A

Elkhart Brass Mfg. Co., Inc. 1302 W. Beardsley Avenue • Elkhart, Indiana 46514 • 1-574-295-8330 • 1-800-346-0250

www.elkhartbrass.com

Valve Motor Replacement Kit P/N 81302001

(Replaces motors P/N 46035001 & 46042000)

Assembly Instructions: Use general purpose petroleum based grease.

1. Grease Thrust Bearing (4) and place between Thrust Washers (3) before inserting them all into the

cavity in the Bushing (6).

2. Lightly grease O-ring (5) and place it in the outside groove on Bushing (6) and then install Bushing

washer/bearing/washer end first into Motor Assembly (1). Push it in until the O-ring can no longer be
seen and the Bushing contacts the bottom of the recess in the Motor Assembly.

3. Lightly grease O-ring (7) and place it in the outside groove on Gear Shaft (8). Align flats on shaft of

Motor Assembly and slot in end of Gear Shaft and then insert Gear Shaft into Bushing as far as
possible. The O-ring (7) should no longer be visible.

4.

Remove original two ½” Thrust Washers, the one ½” Thrust Bearing, & the Worm from the old motor
shaft. (These are the only parts off of the original motor shaft that will be reused.)

5. Assemble Woodruff Key (10), greased

Worm, ½” thrust washer, greased ½” thrust bearing, and ½”

thrust washer, and lightly greased O-ring (9) onto Gear Shaft (8).

6. Peel backer from Warning Decal (11) and attach it to Motor Assembly.
7. Insert O-ring (2) into face groove of Motor assembly flange and install entire assembly into valve gear

case making sure O-ring (2) stays in place.

Advertising