ElmoMC Composer User Manual - Manual

ADDENDUM:
The following changes will be advertized in the next
new version
Content of the changes: (TOTAL-1)
Change #-1
Date JULY 2008
Subject: Motion Monitor Indicators.
Eng.: Ilia Volgust (MTCR # 00-100-20)
Location:
http://www.elmomc.com/support/manuals/MAN-COMPUM.pdf
(Page 3.2.2 Motion Monitor Indicators)
New Change: (also in the Composer's help)
Motion Monitor Indicators
This section enables you to enter parameters in order to display the current status of the
drive. You use the two drop-down list boxes below the Display 1 and Display 2 text
boxes to select two vectors for display.
For linear motors, your vector options are as follows:
• Active Current in amperes
• Auxiliary Position in counts
• Position in counts
• Position Error in counts
• Velocity in counts/sec
• Velocity in m/sec
• Velocity Error in counts/sec
• Velocity Error in m/sec
For rotating motors, your vector options are as follows:
• Active Current in amperes
• Auxiliary Position in counts
• Position in counts
• Position Error in counts
• Velocity in counts/sec
• Velocity in RPM
• Velocity Error in counts/sec
• Velocity Error in RPM