Cleaning, 10 how to use press the on/off switch, Rese t – Braun 5692 User Manual
Page 10
10
How to use
Press the on/off switch
w
to operate the shaver:
• The pivoting shaver head and fl oating foils
automatically adjust to every contour of your
face.
• To shave hard to reach areas (e.g. under the
nose) slide the shaver head «lock» switch
0
to
the back position to lock the pivoting head at
an angle.
• To trim sideburns, moustache or beard, slide
the pop-out long hair trimmer
q
upwards.
Tips for the perfect shave
For best shaving results, Braun recommends you
follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles
(90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
Shaving with the cord
If the shaver has run out of power (discharged),
and you do not have the time to recharge it in the
Clean&Renew station, you may also shave with
the shaver connected to an electrical outlet via
the special cord set
p
.
Cleaning
Automatic cleaning
After each shave, return the shaver to the
Clean&Renew station and proceed as described
above in the section «Before shaving».
All charging and cleaning needs are then
automatically taken care of. With daily use, a
cleaning cartridge should be suffi cient for about
30 cleaning cycles.
The hygienic cleaning cartridge contains alcohol,
which once opened will naturally evaporate
slowly into the surrounding air. Each cartridge,
if not used daily, should be replaced after
approximately 8 weeks.
The cleaning cartridge also contains lubricates,
which may leave residual marks on the outer foil
frame after cleaning. However, these marks can
be removed easily by wiping gently with a cloth
or soft tissue paper.
tr
reset
lock
1
2
trimmer
lock
lock
lock
on
on
of
f
of
f
intensive
sensitive
tr
reset
lock
1
2
trimmer
lock
lock
lock
on
on
of
f
of
f
intensive
sensitive
re
lease
re
lease
high
clean
low
empty
cle
an & dry
trimmer
rese
t
fast cle
an
high
clean
low
empty
cle
an & dry
trimmer
rese
t
fast cle
an
98925301_790cc_NA_S4-38.indd 10
98925301_790cc_NA_S4-38.indd 10
02.02.2009 15:47:03 Uhr
02.02.2009 15:47:03 Uhr