Sheet2, Detail view j (1 : 2.5), Detail view k (1 : 2.5) – ERICO CADDY ROD LOCK Beam Clamp User Manual
Page 2: Detail view l (1 : 2), Detail view m (1 : 2.5), Drawing view127, Drawing view126, Drawing view124, Drawing view128, Drawing view129
Advertising
Tighten the set screw with
60 in-lb(6.8 N-m). Tighten the
jam nut.
Push rod
into beam clamp.
Tighten the set screw with
60 in-lb(6.8 N-m). Tighten
the jam nut.
top of locknut
Top of rod must be
positioned at or above
6
7
Rod adjustment
possible after
locknut tightened.
2
3
3
4
1
Method #1
* Arrows on CADDY
®
ROD LOCK Beam Clamps must always point up.
* Arrows on CADDY
®
ROD LOCK Beam Clamps must always point up.
1
As shipped
4
As shipped
Method #2
Follow installation steps 5-7
from method #1.
Hand tighten top
locknut.
5
Rotate counter clockwise
2 full turns to insert rod
2
Rotate counter clockwise
2 full turns to insert rod
TECHNICAL SUPPORT:
www.erico.com
CFS410_R
INSTRUCTION SHEET
2 OF 2
© 2009, 2010, 2011, 2012 ERICO International Corporation
CADDY
®
ROD LOCK Beam Clamp
Advertising