ERICO ROD LOCK Strut End Bracket - Manual (Page 2)

using 11/16" or 17mm wrench
Tighten with 60 in-lbs [7 N-m] torque
Push CADDY ROD LOCK to engage threaded rods
extended position.
Rotate lock nut
counter clockwise
until reaches the fully
Untighten the flanged screw
Assembly at minimum open position
Open side of strut must
be facing down
Step 2 1" [25mm] minimum
required at both ends
Step 6-1:
Tighten
lock nut on
both sides
TECHNICAL SUPPORT:
www.erico.com CFS491_A
INSTRUCTION SHEET
2 OF 2 © 2014 ERICO International Corporation.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
CADDY® ROD LOCK Strut End Bracket
3/8", M8, M10
Step 1
Step 4
Step 5
Assembly at maximum open position
Step 3
Step 6
Tighten
the flanged screw
by hand
Step 6-2:
Rotate the hex housing to finely
tune the strut height.
Clockwise = adjust assembly down
Counter-clockwise = adjust assembly up