ERICO CADDY ROD LOCK Strut Nut User Manual
Page 2
Step 1
Install CADDY® ROD LOCK Strut Nut on to strut
Step 3
Step 4
Step 2
with 14mm wrench
Tighten the stem nut to 100 in-lbs [11.3 N-m]
Step 4-3:
Counter-clockwise = Adjust assembly up
Clockwise = Adjust assembly down
Rotate the hex housing to finely tune the strut height
Step 4-2:
TECHNICAL SUPPORT:
www.erico.com
CFS500_A
INSTRUCTION SHEET
2 OF 2
© 2014 ERICO International Corporation.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
CADDY® ROD LOCK Strut Nut
3/8", M8, M10
Step 4-1:
Tighten lock nut
on both sides
with insert
Strut Nut
without Insert
Strut Nut
Rotate lock nut
counter clockwise
until reaches the fully
extended position
on both sides
Threaded rod
Push CADDY ROD LOCK to engage threaded rods
Threaded rod
by hand to allow for free rotation
Tighten stem nut to finger tight and then
turn back 1/16 turn (20 degrees)