ERICO Universal Pedestal Clamp - Manual (Page 2)

1
 40 in-lbs [4.5 Nm]
2
3
P 150 in-lbs [17N-m]
P 150 in-lbs [17N-m]
Installation:
For simplest installation CADDY® CAT LINKS J-Hooks, if specified, should be attached to pedestal 1.
clamp before installation on the pedestal.
Attachment of clamp to pedestal: 2.
Secure nuts finger tight approximately equal distance on L-bolt. •
Using a 9/16" wrench or socket, torque nuts to 40 in-lbs [4.5 N-m] •
Conductor installation in MBNUPCJ82 3.
Install parallel conductors on the same plane. •
Using a 5/8" deep well socket torque nuts to 150 in-lbs [17 N-m] •
Conductors must extend at least 1" outside of connector •
CORRECT
INCORRECT
X
(MBNUPCJ82 Only)
(MBNUPCJ82 Only)
R
TECHNICAL SUPPORT
www.erico.com IP8170_G 2 OF 2
INSTRUCTION SHEET
©2010, 2011, 2012 ERICO International
Corporation