ERICO CADDY ROD LOCK Bottom-Mount Duct Bracket - Manual (Page 2)

Push new duct toward
previously installed duct.
New duct
Previously installed duct
Previously installed duct New duct
Fine duct height adjustment by wrench:
Clockwise = duct down
Counter-Clockwise = duct up
Complete duct
joint for Flange or
Slip and Drive
connection.
Step 6: (Optional)
Install fourth screw to
each bracket.
Fourth screw on each
bracket is optional if bracket
is excessively tilted inward.
Gap 1-1/2" [38mm] for Flanged duct or
1/2" - 1" [13mm - 25mm] for Slip and Drive duct
Previously installed duct New duct
Positioned at nearest end
Tighten lock nut
Step 5:
Complete duct joint.
Step 4:
Push duct together.
Step 3:
Position duct for assembly
TECHNICAL SUPPORT:
www.erico.com CFS473_F
INSTRUCTION SHEET
2 OF 2 © 2013, 2014 ERICO International Corporation.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.