ERICO CADWELD for Rebar Splicing System - Manual (Page 9)

7 www.erico.com
Filler Material Remixing And Placement Procedures
1. Cut off top of bag just below closure tie. This will allow
enough remaining bag length to permit remixing.
2. Open bag and then reclose to entrap air. (Starting
material container may be removed if it is convenient.)
3. Fold over cut end of bag, leaving enough open space
within the bag to allow free tumbling of filler material.
4. Using both hands, flip-flop the bag several times,
allowing the filler material to remix.
5. Unfold bag and pour enough filler material into a
prepared crucible to completely cover the crucible-
ceramic and steel-disk assembly. Lift crucible up to
ensure filler material is not leaking. (If it is leaking,
carefully pour the filler material back into the bag and
reseat the steel disk or replace if bent.)
6. Dump the remainder of the filler material into the
crucible, taking care to remove the container of starting
material if it is still in the filler material.