Synchronising two smartfades, Basic midi implementation – ETC SmartFade v3.0.1 User Manual
Page 33
2
Setup
27
Synchronising Two SmartFades
To synchronise playback of two SmartFade consoles, just connect MIDI OUT from console
A to MIDI IN on console B. Now the main playback functions are “mirrored” from console A
to console B.
Functions
•
GO, PAUSE and STOP will be synchronised*.
•
In MEM mode the faders and bumps will be synchronised*
•
SOLO mode will be synchronised for MEM bumps*
•
Grand Master, Blackout and Bumps Master will be synchronised*
* These functions are transmitted from within the Basic MIDI implementation on the
currently set MIDI channel.
.
Basic MIDI implementation
A set of controllers and buttons can be sent and received. This can be used both for Show
Control and to Synchronise two SmartFade consoles.
Controllers
•
1-48 = Master 1-48 (only in MEM mode)
•
124 = Live fader
•
125 = Next fader
•
126 = Bump Master
•
127 = Grand Master
Program Change
•
0 = Reset the Stack to step 0
•
1-99 = GOTO step 1-99 in the Stack
•
100-111 = Memory pages 1-12
•
124 = Pause
•
125 = Start (GO)
•
126 = B.O. not active
•
127 = B.O. active
Note on/off
•
0-47 = MEM bumps 1-48 (only in MEM mode)