ETC Unison DRd Right IO Card Upgrade Kit - Manual (Page 4)

E T C I n s t a l l a t i o n G u i d e
Right I/O Card Upgrade
Right I/O Card Upgrade Kit Installation Page 4 of 4 Electronic Theatre Controls, Inc.
Step 6: Replace the dimmer modules, Station Power Module and Architectural Control Processor
into the slots they were previously removed.
Step 7: Slide the module retention bar to the right and tighten the screws to secure it in place.
Step 8: Supply power to the DRd enclosure.
Step 9: Unless structural changes are being made to the existing system, no dimming or
architectural re-configuration should be necessary. If the system is being modified,
reference the related Architectural Control Processor Configuration and Programming
Guide for configuration setup and operation information.
W A R N I N G : Never power up or operate the Unison DRd enclosure without all modules
installed. Failure to comply exposes you to dangerously high voltages that may
result in death by electrical shock.