ETC Echo Inspire Station - Manual (Page 8)

E T C I n s t a l l a t i o n G u i d e
Station Installation
Inspire Station Installation Guide Page 8 of 8
Install the Wall Plate
The wall plate is secured to the station with magnets that are assembled to the
wall plate.
Step 4: If the wall plate does not fully attach automatically, wiggle the bottom
of the plate until all of the magnets are seated properly to the station
and the plate is secure.
N o t e : When installing a multi-gang wall plate to a station and the
stations are not aligned properly in the back box, the wall plate will
not attach properly.
Loosen the screws that secure the station to the backbox, adjust
each station to improve the alignment, secure the screws, then
retry wall plate installation.
Step 1: Align the top of the wall plate to the station
and angle the bottom approximately 20
degrees.
Step 2: Hook the top of the wall plate to the tabs
located on the station electronics
assembly. To ensure the wall plate is
hooked properly on the top hook, wiggle it
slightly side to side.
Step 3: Swing the bottom of the wall plate down
until the magnets engage.