EUCHNER Electronic-Key Adapter with serial Interface - Manual (Page 14)

Manual EKS Electronic-Key Adapter serial
088796-02-03/05 Subject to technical modifications Page 14/24
7 Setup
Setup is to be performed in the following sequence:
1. Set the DIP switches on the Electronic-Key adapter
(see page 10 chapter 4.4).
2. Check mounting and electrical connection are correct
(see page 11 chapter 5 Mounting and page 12 chapter 6 Electrical connection).
3. After the power supply is switched on, the LED on the front of the Electronic-Key adapter illuminates green.
This indicates that the power supply is present.
4. Insert Electronic-Key in the Electronic-Key adapter. The LED changes to yellow.