EUCHNER EKS FSA with Ethernet Interface - Manual (Page 27)

Manual EKS Electronic-Key Adapter Ethernet
7 Setup
Perform setup in the following sequence:
1. Set the DIP switches on the Electronic-Key adapter
(see section 4.4).
2. Check mounting and electrical connection are correct
(see section 5 and section 6).
3. After connection of the power supply, the LED on the front of the Electronic-Key adapter first illuminates red.
When the connection has been established, the LED illuminates green and signals readiness for operation.
4. Insert Electronic-Key in the Electronic-Key adapter . The LED changes to yellow.
5. Important: for the version EKS FSA, all safety functions must also be thoroughly tested.
7.1 Network settings
You need the following information to integrate the EKS Electronic-Key adapter into the network:
f IP address of the host computer with which you want to configure the Electronic-Key adapter .
f Free IP address that can be assigned to the EKS Electronic-Key adapter (not needed if the IP address is
obtained automatically from a DHCP server)
f Subnet mask of the network in which the Electronic-Key adapter is to be operated
f If necessary, information on valid gateway
f If necessary, information on valid DNS server
Information!
The TCP connection to the Electronic-Key adapter must be made using port 2444. If the Ethernet
ActiveX
®
module is used, this port is set by default. If the connection, e. g., is to be made from a control
system, this port must be set explicitly.
7.1.1 Network settings for a configuration PC with Windows
®
XP
Information!
f It is assumed that you perform initial setup of the EKS Electronic-Key adapter using a configuration
PC as shown in the following example.
f For connection, you need a (Cat5) patch cable with crossed wires (crossover).
f You must first adapt the network settings so that the device can be found in the network (see
section 7.1).
Figure 7: Connection of configuration PC
100420-02-01/09 Subject to technical modifications Page 27/40