EZWatch EZ-TRACK-DOME - Manual (Page 11)

The camera has a built-in heater and blower designed to regulate temperature and ensure
the camera functions in extreme weather. This menu controls those functions.
Heater Display – If this option is turned on, the word ‘Heater’ will display on the screen
when the heater is enabled. Irregardless of this setting, nothing will be shown on the
screen if the heater is turned off.
Heater Mode – Auto allows the camera to control its own heater, off ensures it’s always
turned off while on forced it to be on all the time.
Temperature Set – This setting controls the threshold (In ºC) under which the heater is
activated. Recommended values are 18-20 ºC. Setting the threshold lower may result in
camera fogging or condensation buildup.
Dome Settings 2 -> Cruise Submenu
This menu controls the ‘cruise’ function of the camera. The cruise function allows the
camera to move from preset 1, to 2, to 3, and so on in sequence (up to 30 max), delaying
a short time between each move.
Dwell Time – This setting indicates how long the camera should wait (in seconds) from 5
to 250 after each move before moving to a new location.
Preset List – This selects which bank of 10 presets is being configured for the cruise. 1
corresponds to presets 1-10, 2 is 11-20, and 3 is 21-30.
Below the preset list is a configuration system allowing the user to customize which
presets are included in the cruise and which are not included. The top row is the preset #
in the bank (IE: If the ‘Preset List’ setting is at 1 then the top row corresponds to presets
1 through 10. If the Preset List setting is at 2 then the top row corresponds to presets 21
through 20.)
The bottom row indicates if that preset is part of the cruise or not, with the number 0 if it
is not included in the cruise and the number 1 if it is. A cruise that has only presets 3, 5,
and 10 included would read “0 0 1 0 1 0 0 0 0 1” on the bottom row. If all presets are to
be included then all 10 of the bottom numbers should be set to ‘1’.
Dome Settings 2 -> Tracking Submenu
The final submenu controls the behavior of the Motion Tracking feature of the camera.
Because of the large amount of configuration available for this feature, it includes its own
reset at the top (Default Setting) specific to the Motion Tracking Settings.
Size Sensitivity – This controls how big an object must be to be tracked. This indicates
how large an object must be on the screen for the tracking to follow it. An object larger