Feiss PIER MT - Manual

Assembly Instructions For
PIER MT
(E) 12/11
5
3 /
4
"
(15 cm)
4 3 /
4
"
(12 cm)
4 3 /
4
"
(12 cm)
IMPORTANT:
TURN OFF POWER AT MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE STARTING
INSTALLATION.
Instructions for Mounting
Pier Mount Fixtures
Outdoors and / or in Wet Locations:
1. Mounting surface should be clean, dry, flat
and 1/4" (6 mm) larger than the base of the
Pier Mount on al sides. Any gaps between
the mounting surface and the pier mount
base edges exceeding 3/16" (5 mm) should
be corrected as required.
2. Pier mount should be secured with four 1/4"
(6mm) bolts and the correct anchors
(not provided) as needed for attaching bolts
into mounting surface material. Mounting
holes located approximately 4-3/4" (12 cm)
apart.
3. With silicone caulking compound, caulk
completely around the base edges of the Pier
Mount where it meets the mounting surface
to prevent water from seeping under base.
4. All electrical connections and grounding
should be done following the instructions
sheet included with the fixture.
5. After wiring and grounding connection is
completed then secure the fixture to the pier
mount. Pilot holes need to be located to
match the holes provided in the base cup of
the fixture that fits onto the pier mount.
Install sheet metal screws (not provided) to
secure fixture to
pier mount.
6. If you are not certain how to install this
fixture and make all electrical connections
properly, consult a qualified electrician or
technician before completing installation.