Briggs & Stratton 20209 - Manual (Page 10)

10
11. Start engine according to instructions given in engine
owner’s manual. Also see operating instructions tag
located on the pressure washer.
How to Stop Your Pressure Washer
• Move variable pressure control lever to “Stop” position.
• Turn engine off according to instructions given in the
engine owner’s manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension, turbo nozzle and utility brush,
and slots to hold the cleaning solution bottle and the
detergent siphoning filter.There are also two hooks at the
ends of the handle to hold your spray gun and high
pressure hose.
1. Place nozzle extension through hole on accessory tray,
as shown in Figure 14.
2. Hang chemical solution bottle on “J” hook and place
detergent siphoning filter in last slot on left (Figure 14).
3. Place utility brush in the second to last slot on right in
tray (Figure 14).
4. Place turbo nozzle through hole on accessory tray, as
shown in Figure 14.
5. Place spray gun on hook attached to accessory tray on
right side of unit (Figure 14).
6. Hang high pressure hose on hook attached to accessory
tray on left side of unit, as shown in Figure 14.
How to Use Spray Tips
The quick–connect on the nozzle extension allows you to
switch between four different spray tips.The spray tips vary
the spray pattern as shown below (Figure 15).
Follow these instructions to change spray tips:
1. Engage safety latch on spray gun.
Figure 14 — Typical Accessory Tray
Section 4: Operation
• NEVER exchange spray tips without locking the safety latch
on the trigger.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
CAUTION
40° White 15° Yellow 0° Red
Black
Use to apply
chemical
Figure 15 — Spray Tip Spray Patterns
Low Pressure
High Pressure
CAUTION
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
Avoid injury from kickback.