Gamber-Johnson 7160-0502 - Manual (Page 3)

1/4" Flat Washers and
Nylok Nuts
Front Handle
7160-0500
(360° 0-90° CLEVIS SUPPLIED)
7160-0514
6" Locking Slide Arm
(No Clevis)
•This product should not be positioned in the area where the airbag will be deployed if it is
activated. DO NOT position the equipment in front of an airbag. Equipment positioned in
front of an airbag can cause serious injury or death if an airbag was activated, such as in an
accident.
•If installation of the equipment requires that the equipment be placed in front of an airbag,
deactivate the airbag in the vehicle so it cannot be activated in an accident. In order to
secure permission for deactivating the airbag in these circumstances, contact the National
Highway Traffic Safety Administration at 1-800-424-9393 to gain permission to do so. If you
have any questions or need assistance, call Gamber-Johnson at 1-800-456-6868.
3/3
How to use the 6" Locking Slide Arm:
The 6" Locking Slide Arm is designed to accommodate four motions of adjustment. The
first being a 360 degree swivel that is actuated by the front handle. Pulling out on the
handle releases the gear latch located in the base and allows the mount to swivel. To
latch the arm in place, position the arm in the desired location and release the spring
loaded handle. Wiggle the arm back and forth to make sure the handle has engaged
the teeth on the gear.
The second motion is the slide. To activate the slide, tighten the 1/4" flat washers and
nylok nuts (accessable through the underside of the assembly) so they are snug but not
locked down. The third motion is the clevis 360° swivel. Tightening or loosening the Nylock
Nut on the clevis will adjust the friction of Clevis rotation. The fourth motion is the Clevis tilt.
7160-0500 comes with a 0-90° tilt Clevis. The 7160-0502 comes with an Angled Low Swivel
and does not tilt.
WARNING