Gamber-Johnson 7160-0318-xx-blue - Manual (Page 4)

MOUNTING THE DOCKING STATION
Mount docking station to mounting system using the four 1/4-20 UNC mounting holes on the bottom of
the dock. Four 1/4-20 UNC x .50 Button Head Mounting Screws are provided in the hardware bag.
* Recommended torque: 75 in-lbs. Over tightening mounting hardware may damage docking
station.
* Use of hardware longer than 5/8" may damage docking station.
This docking station is designed to be used with a variety of Gamber Johnson mounting systems.
Installation instructions for other Gamber Johnson products are provided with each individual product.
Clevis
(Not Included)
1/4-20 x .50 (Qty. 4)
Button Head Mounting Screws
Pg 4
WIRELESS ANTENNA SWITCH
If wanting to use external antenna, connected by cable
to the WAN port on the dock:
Position the switch toward the "EXT" side.
If wanting to use antenna built into the computer or PC
Card type antenna:
Position the switch toward the "INT" side.
CF-31MK1 computers are not effected by the
"Antenna Switch". To disable external antenna on
all CF-31 MK1 computers, install Panasonic service
part No. (DFHR3S40ZA, DFHR3S39ZA or
DFHR3S38ZA (dual) over the RF connection on
back of the computer. This part can be ordered
from Panasonic (1-800-527-8675) and support will
send request to service department. If the CF-31
Model No. is followed by the following Alpha's you
know it is a MK1 model: CF-32A, B/E, C, D or G.
All other CF-31 models work as stated above.
Wireless Antenna Switch
EXT/INT