Gamber-Johnson 14422 - Manual

INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Rev.A INST-538
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2010 Gamber-Johnson, LLC
Printing Spec: PS-001
DODGE CHARGER FILLER PANEL
14422
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
12v jacks:
1. Remove a 12v jack from the console by pressing the jack through from behind.
2. Seperate the cap and ring from the 12v jack by depressing the tabs inside the
jack (Figure 1) then pressing the metal sleeve out of the plastic ring.
3. Remove the knockout from the filler panel
4. Install the ring and cap into the filler panel. Note orientation of notch.
5. Install the 12v jack into the ring.
6. Repeat for second 12v jack if desired.
USB/MP3 Jack:
1. Remove USB/MP3 box from factory console by depressing tabs on either side.
2. Remove the square knockout from filler panel.
3. Snap the USB/MP3 box into the opening in the filler panel.
FIGURE 1
CAP AND RING
12v JACK
KNOCKOUT
MP3/USB
KNOCKOUT