Gamber-Johnson 7160-0330 - Manual (Page 2)

Attaching a Universal Keyboard to the Keyboard Tray:
Attach the keyboard to the keyboard tray with the 1 x 10-in strips of Dual Lock found in hardware bag
7120-0473. There are (4) 10" long pieces of dual lock in the hardware bag.
1. If not preassembled by the factory; attach the pieces of dual lock together to form two pieces that have the
release liners on the out side.
2. Without removing the release liners place the pair of dual lock strips on the keyboard tray and place the
keyboard on top to make sure the Dual lock is located in the correct place for your application.
3. Once the location of the keyboard has been determined, remove the release liner from one side of the dual
lock strips and attach the strips to the keyboard tray.
4. Remove the remaining release liners from the top sides of the dual lock strips and attach the keyboard.
Various keyboard types
Keyboard Tray
Adhesive backed Dual Lock
Removing the Keyboard Tray from the Base:
The keyboard tray with the keyboard attached can be removed from the base mount by activating the latch at the
back of the tray. Rotate the keyboard up about 30 degrees to easily seperate the tray and base.
Rotate up
then seperate.
Activate latch
Caution:
Prevent the keyboard tray from entering the airbag zone of the vehicle. Ensure the loose keyboard tray is
secured to the keyboard base before moving the vehicle.
Page 2 of 3