Gamber-Johnson 7160-0499-01 - Manual

Rev.C INST-624
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
The following instruction sheet is for mounting the part numbers listed
INSTALLATION INSTRUCTIONS
fork trucks.
Product Revision
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Printing Spec:
above. These mounts are designed to attach to the pillars of various
PS-001
level. (See figures 1 & 2).
3/8" dia. carriage bolts.
The assembly attaches to the overhead guard leg on the fork truck. It can fit a
SCANNER HOLDER ASSEMBLY
Form
rectangular pillar from 1 1/2" to 5" wide. The mounts are held in place with
Attach the Holder assembly to the pillar using the 3/8" carriage bolts and
back plate.
The assembly should be positioned so the top surface of the mount is relatively
1 of 3
7160-0499-01
© Copyright 2013 Gamber-Johnson, LLC