Gamber-Johnson MAX3 Mounting System - Manual

INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Rev.B INST-494
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or conseq uential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupan ts, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufacture s specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2012 Gamber-Johnson, LLC
Printing Spec: PS-001
maX
3
Mounting System
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or conseq uential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupan ts, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufacture s specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
Thread Adapter
Round Plate
Knuckle
Extension
Device End
1. Secure Round Plate or Quick Release Mount to mounting
surface using ¼” hardware.
2. Attach the Suction Cup Mount to a hard flat surface. Clean
the mounting surface and the rubber suction cup before
pressing the suction cup against the mounting surface and
pushing down the locking lever.
Note: The Suction Cup Mount is not intended for use in a
vehicle.
3. Assemble components using Thread Locking Adhesive
supplied with the maX
3
Knuckle.
4. If using an Extension it must be mounted to the mounting
plate on the Base End. Do Not Use Extension On Device
End Of Mount.
5. Allow Thread Locking Adhesive to cure for a minimum of
12 hours before attaching your device to the device end of
the mount.
Base End
Vesa Plate
Suction Cup
Mount
Knuckle
Round Plate
Quick Release
Mount