Gamber-Johnson 7160-0390-xx - Manual

PANASONIC TOUGHBOOK CF-31 MAG DOCKING STATION, w/GPS
INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7160-0390-04, -05, -06, -10, -11, -12 Rev.A INST-552
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
Printing Spec: PS-001
This instruction sheet is a supplement to INST-509 & INST-398 for the following products:
Panasonic Toughbook CF-31 docking station with no integrated high gain antenna pass-thru cables.
Item No. 7160-
0390-04 (Button lock, No RF, Int. power)
Item No. 7160- 0390-10 (Auto lock, No RF, Int. power)
Panasonic Toughbook CF-31 docking station with single integrated high gain antenna pass-thru cable.
Item No. 7160-
0390-05 (Button lock, Single RF, Int. power)
Item No. 7160- 0390-11 (Auto lock, Single RF, Int. power)
Panasonic Toughbook CF-31 docking station with
dual integrated high gain antenna pass-thru cable.
Item No. 7160-
0390-06 (Button lock, Dual RF, Int. power)
Item No. 7160- 0390-12 (Auto lock, Dual RF, Int. power)
REFERENCE INST-509 & INST-398 FOR COMPLETE INSTALLATION AND USE INSTRUCTIONS
The GPS module is powered via the CF-31 Mag Docking Station power cable. Follow INST-398 for
the dock wiring considerations.
The GPS antenna is located under the gray plastic cover on top of the Mag Dock. The dock should be
installed so that the gray cover has a clear view of they sky through the windshild.
The hardware bag contians a harness that allows for four inputs and three outputs (I/O Harness) The
ouputs should be connected using standard automotive relays.
INSTALLATION
Figure 1 - I/O Harness
Wire Color Signal/Description
Blue Wire Input 1 ‐ Visible on Screen
Orange Wire Input 2
Violet Wire Input 3
Grey Wire Input 4
Green Wire Output 1 ‐ Starter Disable Relay
Brown Wire Output 2 ‐ Honk Horn
Yellow Wire Output 3 ‐ Unlock Doors