Gardman Party Lantern v1 User Manual
Page 2
Assembly:
n
Remove the lantern carefully from the packaging to
avoid damage.
n
Turn head assembly clockwise to access the on/off switch and
move switch to ‘on’.
Installation:
n
Maximum sunlight will give the internal battery the best
charge and so give best results.
n
Position solar lights where they are free from cover or shade
and, ideally, in a position that receives full sun throughout the
day.
n
Avoid other light sources which may cause solar lights to flicker
on and off. Also allow a space of approx. 1.5m (5ft) between
solar lights.
n
Solar lights will not be very bright or long lasting until a full
day’s sunlight has been received. Alternatively, batteries can
be charged to full capacity in a battery charger before use.
n
Lights can be hung or placed in the garden on a ground
stake.
Maintenance:
n
If solar panels get dirty, the charging capacity will be
reduced. Clean panels occasionally with a damp cloth – avoid
harsh detergents or solvents as these can damage
the panel.
n
Batteries can be given a temporary boost in a battery
charger if there has been limited sun or extra light is
needed for a special occasion.
n
Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. The batteries are
housed under the head of the light and
can be easily accessed by turning the head of the light
clockwise.
n
The batteries (1 x AAA) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose a low
power output (mAh). Gardman replacement
batteries are ideal for the purpose.
n
Do not use the lights in very wet and windy conditions.
n
Low winter light levels or harsh weather in your locality may
lead you to decide to store your solar lights indoors until
conditions improve. If so, clean and dry the lights
and remove the batteries: store in a dry spot and
reassemble in spring as described in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may be
caused by one of the following:
n
Ensure the switch, if present, is in the on position and any
battery tabs removed.
n
Low light levels caused by the position of the light,
lack of sun or short daylight hours will shorten the
light duration.
n
Other lighting can cause flickering in a solar light or even
prevent it operating.
n
Check the batteries in case they need replacing: see
‘maintenance’ above.