General Machine Products 70483 Hydraulically Limited Cable Puller - Manual (Page 10)

H
YDRAULICALLY
L
IMITED
F
IBER
O
PTIC
C
ABLE
P
ULLER
O
PERATION
9.0 D
ISASSEMBLY AND
S
TORAGE
1. Release foot control valve and turn off hydraulic power source.
2. Disconnect all hydraulic hoses and wipe off any residual hydraulic fluid from
the quick-disconnect fittings.
3. Place caps and plugs onto quick-disconnect fittings.
4. Remove the capstan from the motor assembly by pushing the capstan
inward towards the motor then rotate the capstan counterclockwise
approximately a Quarter turn.
5. Remove the capstan from the drive shaft and store the capstan.
6. Remove the hitch pin securing the motor assembly to the stand and lift
motor assembly from stand.
7. Remove the extension legs from the stand and place extension legs into the
storage brackets on the stand assembly.
8. Store all components of the hydraulically limited cable puller securely.
10.0 C
ARE AND
M
AINTENANCE
General:
All components should be cleaned and securely stored to prevent damage.
Gearbox:
EP 80/90 GL-5 is the recommended lubricant.
Lubrication should be changed after the first 50 hours of operation, and every
500 hours thereafter.
Foot control valve:
Keep dirt and debris from inside of foot control valve housing.
Clean and place the caps and plugs onto the quick-disconnect
fittings when not in use.
10