Brother LW6091001 - Manual (Page 54)

EDITING A LABEL
50
Creating a Bar Code Label
Setting Bar Code Parameters
Press the Setup key to display the Setup menu, select “Bar Code Setup” using
the or key, and then press the OK or Enter key.
The Bar Code Setup screen is displayed.
Select an attribute using the or key, and then set a value for that attribute
using the or key.
Press the OK or Enter key to apply the settings.
z
Bar Code Settings
z
1
2
Characters may not appear below the bar code even when "On" is selected for "Under #",
depending on the tape width being used, the number of lines entered, or the current
character style settings.
3
New settings are NOT applied if you do not press the OK or Enter key.
• The "C-Digit" (Check Digit) attribute is only available for the CODE39, I-2/5 and CODABAR
protocols
• Press the Escape key to return to the previous step.
• Press the Space key to set the selected attribute to the default value.
• Refer to the Bar Code Settings table for a list of all available settings.
Attribute Value
Protocol
CODE39, CODE128, EAN-8, EAN-13,
GS1-128 (UCC/EAN-128), UPC-A, UPC-E, I-2/5 (ITF),
CODABAR
Width
Small
Large
Under#
(characters printed
below bar code)
On
Off
C.Digit
(check digit)
Off
On
(only available for the CODE39, I-2/5
and CODABAR protocols)