Grayhill Joysticks/NavCoders 60AR Series - Manual

Grayhill, Inc. • 561 Hillgrove Avenue • LaGrange, Illinois 60525-5997 • USA • Phone: 708-354-1040 • Fax: 708-354-2820 • www.grayhill.com
Optical and Mechanical
Encoders
Optical Encoders
Ш1.000
25,4 [ ]
.460
11,68 [ ]
.642±.003
16,31±0,07 [ ]
Ш
PANEL SEAL I.D.
.750
19,05 [ ]
Ø
PANEL SEAL O.D.
.850
21,59 [ ]
.548
13,92 [ ]
.600
15,24 [ ]
SHAFT FLAT
.219±.002
5,56±0,05 [ ]
]
.940 ±.020
23,88 ±0,5 [ ]
.610 ±.015
15,49 ±0,38 [ ]
REF.
JOYSTICK
PIVOT POINT
.172
4,36 [ ]
.853 ±.015
21,67 ±0,38 [ ]
.932 ±.020
23,67 ±0,5 [ ]
M17x1.0
THREAD
HEADER IS
SAMTEC P/N
ASP-120519-01
(.050" SPACING)
MOUNTING SURFACE
Ø.250 ±.002
6,35 ±0,05 [ ]
.250
6,35 [ ]
.046 ±.015
1,17 ±0,38 [ ]
.280
7,11 [ ]
.020
0,51 [
.338
8,59 [ ]
.025x45°
[0,63]x45°
CHAMFER
PANEL SEAL GASKET NOT SHOWN IN LOWER
VIEWS TO ILLUSTRATE MOUNTING SURFACE
SCALE 2.000
.652± .003
16,56± 0,07 [ ]
.679± .003
17,25± 0,07 [ ]
Ø
PANEL SEAL GASKET NOT SHOWN TO ILLUSTRATE MOUNTING SURFACE
Ø.250 ±.002
6,35 ±0,05 [ ]
.250
6,35 [ ]
.046 ±.015
1,17 ±0,38 [ ]
.020
0,51 [ ]
.280
7,11 [ ]
.338
8,59 [ ]
.025x45°
[0,63]x45°
CHAMFER
CABLE LENGTH
±.200
[±5,08]
.455 ±.015
11,56 ±0,38 [ ]
.605 ±.015
15,37 ±0,38 [ ]
.927 ±.020
23,55 ±0,5 [ ]
REF.
JOYSTICK
PIVOT POINT
.172
4,36 [ ]
.853 ±.015
21,67 ±0,38 [ ]
M17x1.0
THREAD
CONNECTOR IS
AMP P/N 215083-8
OR EQUIVALENT
MOUNTING SURFACE
SerieS 60Ar
rugged and Sealed Joystick
FeATUreS
• Three-in-One Joystick, Optical Encoder and Pushbutton
• Shaft and panel sealed to IP67 against liquids and particulates
• Choices of knobs, cable length and termination
• Customized solutions available
APPLiCATiONS
• Aerospace
• Military vehicles and devices
• Mobile electronics for outdoor use
DiMeNSiONS in inches (and millimeters)
Unless otherwise specified, standard tolerance are:
Linear ± .025
Diameter ± .010
Angle ± 2.0°
Angle of Throw: 18= 18° or 20 positions, 08= Non-detent or 20 positions, 00= Non-turn
Joystick: 4= Four contacts & four directions; 8= Four contacts & eight directions
60Ar18-4-060S
Termination: 0.050" center P= pin header; C= connector; S= stripped cable
Cable Length: 020 thru 250 in 1/2 inch increments, 060= 6.0 inch cable, leave blank if pinned
OrDeriNg iNFOrMATiON
For prices and custom configurations, contact a local sales office, an authorized distributor, or Grayhill's sales department.
Pin Version
Cable Connector Version
recommended Panel Cut Out