GreenGuard Residential Building Wraps - Manual (Page 12)

G R E E N G U A R D
®
M O I S T U R E M A N A G E M E N T
1-800-241-4402
www.TrustGreenGuard.com
GreenGuard® MAX ™ and RainDrop ® (US Patent Nos. 6,869,901/6,761,006/7,196,024/6,550,212 and
MX Patent Nos. 246453/241682) ®are registered trademarks of Pactiv LLC
©2014 Pactiv LLC
7/14
INSTL-RES
For the most current product information, go to www.TrustGreenGuard.com.
For more information on specific building product recommendations and limitations, contact your local Pactiv representative.
G R E E N G U A R D
®
M O I S T U R E M A N A G E M E N T
12. Alternative Method for Sealing
Overlapped Building Wrap Seams
Common adhesives can be used to seal overlapped seams of
GreenGuard® Air Barrier Building Wraps. It is applied using a
standard caulking gun and is easily extruded.
When using common adhesives to seal building wrap seams as an
alternative to using seam tape, install the adhesive as follows:
Apply 1/8 to 1/2 inch bead of sealant on the lower course
of building wrap. Make sure that the horizontal overlap of the
upper building wrap course is at least 2 inches. Apply hand
pressure to the overlap to create a full seal.
Go to www.TrustGreenGuard.com for a list of adhesives (see
Technical Bulletin No.TB011 under “Product Literature”.)