Hawke Optics LRF Pro 900 - Manual (Page 4)

7 8
stanDarD moDe
Standard mode measures the straight line distance to
the target you are aiming at.
When there is nothing displayed to the left of the
distance you are in standard mode.
If you hold the ON button while in standard mode the
range finder will continuously scan so you can move
around and get constant updates of the distance.
LASER
DISTANCE MEASURED
operation
Adjust the dioptre setting to get a clear image for
your eyesight.
When turned on the range finder will start in the
same mode it was in when last used.
To cycle through the modes simply press the MODE
button until you come to the setting you desire.
Simply press the ON button to laze the target you are
aiming at.
The signal strength is displayed beneath the aim
point. A minimum of 6 bars is needed to operate, 10
bars is the maximum strength.
The Hawke Laser Range Finder will automatically turn
off when not used for 15 seconds.