Esl600 series operation manual, Adjusting torque, Inserting / removing bits – HMC Electronics CESL611-ESD Delta Regis Brushless Electric Screwdriver User Manual
Page 3: Operation proper grip
ESL600 Series
Operation Manual
Adjusting Torque
Page 3
Insert the power plug into a receptacle and set the FWD/REV switch to the “F” position.
1.
Apply the bit to the screw head and press the lever or push the tool downward, the start switch will be
2.
turned ON and the motor will start running.
Once the screw has tightened and reached the torque you had set, the tool will shutoff automatically.
3.
To reset the tool, release the lever or release the bit from the screw head.
4.
To remove the screw, set the FWD/REV switch to the “R” position.
5.
Determine the torque output of the tool by checking a tightened
1.
fastener with a torque wrench.
Increase or decrease the torque by rotating the Torque Adjustment
2.
Ring.
Rotating the Ring clockwise increases torque output.
3.
Rotating the Ring counterclockwise decreases torque output.
4.
Check the adjustment with a torque wrench.
5.
A number of factors
will affect torque output from one application to another. Final
torque adjustment should be made on the application through a of
series of gradual increases. Always start below the desired torque
and work upward.
Remove the housing nut from the electric screwdriver after setting
6.
the desired torque and attach the torque locking sleeve. This will
help avoid accidental torque adjustment.
Note: The numbers on the torque scale are for reference only and do
not indicate actual torque value.
Inserting / Removing Bits
Push the bit retainer inwards and it will release. The bit can now be inserted or removed.
Operation
Proper Grip
To prevent damage to your investment, it is essential that all users have a proper
and secure grip on the screwdriver at all times. As shown, the user has a firm grip
on the screwdriver with the FWD/REV switch easily reached with the thumb and
the start lever with the index finger.
Note: A firm grip is required to prevent the tool from spinning and possibly
damaging the unit.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440