HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System User Manual
Page 26
• BATCH REJECT: (Some portion of the task did not complete within acceptable parameters or the
task was aborted)
• TOOL TRIGGERED: (All triggering
output is only available as a solid output, not momentary or repeating)
• TORQUE > THRESH: (The current torque reading from the tool is greater than the programmed
threshold torque in the parameter being run. This output is only available as a solid output, not
momentary or repeating)
Note: Ensure compatibility of the output receiving device with the user’s programmed signal
duration. Signal pulses less than 50ms could possibly be interpr
Page 26
: (Some portion of the task did not complete within acceptable parameters or the
(All triggering criteria as defined in the setup screen have been satisfied. This
output is only available as a solid output, not momentary or repeating)
(The current torque reading from the tool is greater than the programmed
rameter being run. This output is only available as a solid output, not
Ensure compatibility of the output receiving device with the user’s programmed signal
duration. Signal pulses less than 50ms could possibly be interpreted as noise by the receiving device.
: (Some portion of the task did not complete within acceptable parameters or the
criteria as defined in the setup screen have been satisfied. This
(The current torque reading from the tool is greater than the programmed
rameter being run. This output is only available as a solid output, not
Ensure compatibility of the output receiving device with the user’s programmed signal
eted as noise by the receiving device.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440