Humanscale Access Rail - Manual

Access Rail
Installation
Instructions
Rail Installation Cable Clips
1. Fit the cable clip into the bottom track of the rail
and turn 90 degrees.
1. Remove the top screws
(a), caps (b), and any collars
(c) that will be installed above
the rail.
2. Align the extrusions on
the ends of the rail with the
extrusions on the collars, and
slide the rail down until it
rests on the stop ring (d).
3. Install any collars that will
be used above or at the next
rail level.
4. Repeat step 2 and 3 until all rails are installed.
5. Replace the post top caps and screws.
6. Tighten all clamp mounts, Bolt mounts, or
install direct mounts.
a.
b.
d.
c.