HYDAC EDS 1700 - Manual (Page 29)

29
E
Setting Display Setting Pre-
range setting
Primary display (Primary) ACT/ ACT.
Display value which should remain S.P.1..
remain permanently in the display: S.P.4/
"ACT.": current pressure MAX
"S.P.1" .. "S.P.4": switching point 1..4
"MAX": maximum value
Display filter (Display) SLOW/ MED.
"SLOW": display reacts slowly to pressure MED./
fluctuations. FAST
"MED.": display reacts normally to pressure
fluctuations.
"FAST": display reacts quickly to pressure
fluctuations.
Determining the display range BAR/ BAR
(RANGE) PSI/
"BAR": The pressure is displayed in bar. FREE
"PSI": The pressure is displayed in psi.
"FREE": The display range can be defined
by the user. If this setting is
selected, then decimal places
and upper and lower display range
must be set. (see below)
Example: If the display range is
changed to 0..215.5,
the display value 215.5
corresponds to the
nominal pressure of the
unit.
Application: Display of other units
which are proportional
to the pressure
e.g. KN, kg, ...