HYDAC EDS 8000 - Manual (Page 8)

User manual EDS 8000 US Page 8
Status 09.09.2009 HYDAC ELECTRONIC GMBH Part No. 669820
Example for switch output 1 (normally closed and normally open function):
Abbreviations: "FH1", "FH2" = upper switch value 1 / upper switch value 2
"FL1", "FL2"
= lower switch value 1 / lower switch value 2
"FNO" = normally open when window function is active
"FNC" = normally closed when window function is active
NOTE
:
• It is only possible to set the switch point (SP) if it is higher than the respective
switch-back point (RP). In the case of low SPs we recommend setting the RP
first.
• The window function only works properly (switching on and off) if all switch
values (including the safety margin) are above 0 bar and below the nominal
pressure range.
6.2 Setting ranges for the switching outputs
Measuring
range Lower limit of
RP / FL Upper limit of SP
/ FH Min. difference
between
RP and SP or
FL and FH Increment
in psi in bar in psi in bar in psi in bar in psi in bar in psi in bar
0 .. 500 0.. 25 5 0,25 500 25 5 0,25 1 0,05
0 ..1000 0.. 40 10 0,40 1000 40 10 0,40 2 0,10
0 ..3000 0 ..100 30 1,00 3000 100 30 1,00 5 0,20
0 ..6000 0 ..250 60 2,50 6000 250 60 2,50 10 0,50
0 ..9000 0 ..400 90 4,00 9000 400 90 4,00 20 1,00
0 ..600 6,00 600 6,00 1,00
* All ranges given in the table can be adjusted by the increments shown.
Rückschaltwert
Schaltwert
Schaltwert
Rückschaltwert
Sicherheitszone
Sicherheitszone
Ein
Aus
FL1 minus 0,4%FS
FL1
FH1
t
P
Ein
Ein
Aus
Aus
Ein
Aus
FNO
FNC
Schlie ßerfunktion
Ö ffnerfunktion
Rückschaltwert
Schaltwert
Schaltwert
Rückschaltwert
Sicherheitszone
Sicherheitszone
Ein
Aus
FL1
FH1
t
P
Ein
Ein
Aus
Aus
Ein
Aus
FNO
FNC
Schlie ßerfunktion
Ö ffnerfunktion
FH1 plus 0,4%FS
On
Normally open function
Off
On
Normally closed function
Off
Reverse switch point
Switch point
Switch point
Reverse switch point
Safety zone
Safety zone
Off
On
On
Off