HYDAC HMGWIN 3000 - Manual (Page 17)

HMGWIN 3000 English Page 17
Edition 06/2007 – V02 R01
Anchor
o
The checkbox in front of “Anchor to measured value“ is initially activated
(i.e. checked). To enter text without anchoring it to a measured value, deacti-
vate this function by clicking on the checkbox.
o
If the checkbox is activated you can select the sensor (measurement channel)
to which the remark is to be anchored (checkmark in the checkbox of the re-
spective sensor).
o
You can also indicate the time at which the remark is to be anchored to the
measurement curve. You can either enter the time in ms or change it by click-
ing the arrow keys next to the time box with your mouse. One click on one of
the arrows => corresponds to a change by the preset measurement rate.
• When you are finished entering your settings, confirm by clicking on “OK“.
• If you click on “Cancel“ your entries will be discarded.
• After clicking on “OK“ the Remark window closes and the remark box can now be
seen.
If anchoring has been activated, the remark box is linked to the selected curve by a
line. The circle at the end of the line shows which measured value the remark re-
fers to.
If anchoring has been deactivated, only the remark is visible.
• The remark can be edited and shifted later providing the remark function has been en-
abled.
The position at which the remark is anchored to the measurement curve can be
shifted by moving the mouse pointer over the anchor position. If you hold the left
mouse button down you can drag the anchor to the position desired. If you have
entered the placeholder it is adjusted accordingly when you release the mouse
button. The anchor point is always a measured value as the remark is anchored to
the measurement curve.
The remark box itself can be shifted by moving the mouse pointer over the remark
box (it is now blue-highlighted; the square turns into a hand pointer, 3 handles ap-
pear in the lower right corner). Click and hold down the left mouse button and mo-
ve the remark box to the required position.
To edit the text or manually enter another "anchor time", click on the 3 handles in
the lower right corner.
The remark box opens again.
“OK“ , “Cancel“ and “Delete“ appear in the bar at the bottom of this window.
o “OK“ = apply changes
o “Cancel“ = close window and discard changes
o “Delete“
= delete the entire remark