INCRA IBOX - Manual (Page 8)

INCRA IBOX OWNER’S MANUAL
Manufactured by Taylor Design Group, Inc. P.O. Box 810262 Dallas, TX 75381 W W W . I N C R A . C O M
Page 8
Get set…
1. “Kiss” Calibrate
With the positioning lock knob loose, you need to
“kiss” calibrate the IBOX (YOUR tABLe sAW
OR ROUteR tABLe sHOULD stILL Be
UNPLUGGeD). To do this, slide the IBOX in your
miter channel to a position adjacent to your cutter.
Now hold the red knob as you rotate the silver
micro-adjust knob to move the pin plates. You’ll want
the pin plates to just touch the blade, Fig. 15 and
Detail 15A. If you are setting up at the router table,
you may need to rotate the cutter by hand to confirm
that the cutter just touches the pin plates. This “kiss”
calibration step zeros the IBOX to the edge of your
cutter. Subsequent adjustments to the pin plates
made by turning the red knob will not alter this initial
calibration.
2. Adjust Pin Plates for test Cut
With the positioning lock knob still loose, rotate the
red knob clockwise to move the nearest pin plate
about 1/8” or more away from the blade, Fig. 16.
You’ll notice that the pin plates will simultaneously
move away from each other as they move away from
the blade. This is OK. Your “kiss” calibration setting
is automatically retained. tighten the black
positioning lock knob located on top of the
IBOX fence.
3. Position stock Ledges
Slide the blade side stock ledge to about 1/8” from the
cutter then re-tighten the fasteners. For reference,
the blade side stock ledge refers to the
stock ledge that is nearest to the cutter
while the pin plate side stock ledge refers
to the stock ledge that is on the other side
of (and nearest to) the pin plates. Slide the
pin plate side stock ledge up to contact the pin plates
and re-tighten the fasteners, Fig. 17. Slide the IBOX
back and forth in the miter slot to make sure that the
blade is clear of both the pin plates and the blade side
stock ledge.
Fig. 15 “Kiss” Calibrate
3) Rotate
silver knob
until pin
plates
“kiss” the
blade
Fig. 16 Adjust Pin Plates for test Cut
Rotate red knob
clockwise until approx.
1/8” between blade and
closet pin plate Fig. 17 Position stock Ledges
Slide to 1/8”
from blade and
tighten fasteners
Detail 15A
Blade
should just
touch the
pin plates
1) Loosen locking knob
2) Hold
red
Knob
in place
After adjustment
tighten positioning
lock knob!
1/8” approx.
Slide to contact
pin plate and tighten
fasteners
Blade side
stock ledge Pin plate side
stock ledge