INCRA Intelli-Fence - Manual (Page 4)

Follow these steps to adjust either the infeed or outfeed fence for
“in-line” or “offset” fence applications, see Fig 7:
Loosen the rear mounting screws on the Hi-Rise fence brace.
Using the supplied hex key, loosen the two socket head
screws through the large holes in the fence. Loosen each
screw one to two full turns, depending on the amount of
adjustment range needed.
Adjust the fence by sliding the rear wedge:
(+) to move the fence forward, slide the wedge
to the left to move the (+) end of the scale
toward the hairline cursor.
(-) To move the fence backward, slide the
wedge to the right to move the (-) end of the
scale toward the hairline cursor.
Note: The numbers on the scale represent
hundredths of an inch. Each of the smaller
tick marks on the top of the scale represent
.002" (two thousandths of an inch).
Tighten the two socket head screws
through the large holes in the fence.
Tighten the rear mounting screw on the
Hi-Rise fence brace.
First: Loosen rear
brace mounting screw
FIG. 7
Offset adjustment–
top view
4
Offset adjustment
Offset Adjustment
Offset Adjustment
5
4
OPERATION
1
2
3
Operation
The infeed and outfeed fences of the
Intelli-Fence can be moved independently
in two directions to provide a variety of
setup configurations. By making the
offset
adjustments described below, you can
position the fences “in-line” for standard
routing operations such as grooving,
rabbeting, and joint making, or you can
“offset” the infeed and outfeed fences for
specialty cutting applications such as
shaping or jointing an edge. The
gap
adjustment allows adjustment of the opening
between the infeed and outfeed fences from
5 / 8 " to 3 3 / 4 ". Follow the step by step
instructions below to familiarize yourself with
these two basic adjustments, then do the
initial fence and scale setup described on
page 5 and you’ll be ready to put your new
Intelli-Fence to work.
Caution: Always turn off the power and
make sure the router bit has come to a
complete stop before changing the setting
of any part of the Intelli-Fence.
Second: Loosen (2) socket head
screws through large holes in fence
Third: Slide rear wedge to
adjust fence offset
Fourth: Re-tighten (2) socket head screws
Note: Hi-Rise fence cap removed for clarity
Fifth: Re-tighten rear brace mounting screw