Trim build-it panel to blade – INCRA Build-It Panel User Manual
Page 4
System
it
®
7. Trim Build-It Panel to Blade
Raise the saw blade about 3/4” and make a cut to trim off the portion
of the panel that extends beyond the line of cut,
Fig. 9. Now, when
you return the left hand Build-It assembly to the table saw, the right
hand “drop panel” can be positioned adjacent to the blade and locked
in place by tightening the two Miter Slider expansion mechanisms to
provide workpiece cutoff support.
Fig. 9 Trim Build-It Panel to Blade
Fig. 10 Sliding Cutoff Sled
Fig. 11 T-Track Fence
Fig. 10 shows the completed Build-It assemblies put together to create
a very useful sliding cutoff sled. The wooden fence shown includes the
addition of INCRA’s T-Track and T-Track Plus, see
Fig. 11 for dimensions.
The fence is held in place with a pair of Build-It Brackets and the knobs
included with the brackets. This arrangement allows the fence to be
positioned at any location and at any angle on top of the sled. The
workpiece is positioned with a user made wooden stop and is securely
held in place with the INCRA Build-It Clamp.
3/4” wide x 1/2”
deep groove
1
3
/
4
”
1
1
/
4
”
5
/
8
”
MADE IN THE
USA
Manufactured by:
Taylor Design Group, Inc.
P.O. BOX 810262 Dallas, TX 75381
www.incra.com
INCRA Tools are protected by one or more of the following US patents:
#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457, #6,557,601, #6,672,190.
Other patents granted or pending.
INCRA is a Registered Trademark of Taylor Design Group
©2007 Taylor Design Group, Inc.