INCRA Track & Shop Stop - Manual (Page 5)

Following are just a few examples of the many
applications you'll discover for your new INCRA Track.
The illustrations represent food for thought and contain
few actual dimensions since your INCRA Track
applications will require dimensions that depend on
your particular tools.
When designing your own applications just remember
the INCRA Track and Shop Stop are the perfect
solution to any cutting or drilling operation that requires
the duplication of multiple stop positions.
INCRA Track System Owner’s Manual 5
APPLICATIONS
FIG. 13
Option #2
Miter gauge
Of course, any miter gauge will allow you to crosscut a
board to length, but for most miter gauges accurately
cutting to length means endless trial and error cutting
that usually leads to mediocre results. Adding an INCRA
Track and Shop Stop to your miter gauge will put an end
to trial and error forever. You'll find your crosscuts not
only accurate, but repeatable as well. For most miter
gauges the easiest mounting will be as shown in Figs.
12 or 13. Note that the wooden mounting bracket
shown in Fig. 12 must be 1
3 ⁄ 4 " or less in height. Fig. 14
shows another mounting option where the rear T-slot on
the INCRA Track is raised to align with the holes in your
miter gauge by mounting an auxiliary fence to the front
face.
FIG. 14
Option #3
FIG. 11
Miter gauge
#10 -32
machine screws
#10 wood
screw
#10 flat
washer
1 1 / 2 " wide
wooden piece cut
to match track
length. Thickness as required
to raise rear T-slot to align with
miter gauge mounting holes.
#10 -32 rectangular
nut (supplied)
FIG. 12
Option #1
#10 -32
machine screw
1 / 4 " thru
hole
#10 wood
screw
#10 flat
washer
5 / 8 "
1 3 / 4 " max Wooden
mounting bracket
#10 -32
rectangular nut
(supplied)
#10 flat washer
A 3 / 4 " thick wooden auxiliary fence should be cut
to match track length (or longer if desired).
Adjust auxiliary fence height as required to
raise rear T-slot to align with miter
gauge mounting holes.
#10 -32
machine
screw
#10 flat washer
Note: Use drill and counterbore
dimensions – shown in Fig. 10, pg. 4.
#10 flat washer
#10 - 32
machine screw
#10 - 32 rectangular
nut (supplied)
#10- 32 hex nut
Side View
Side View
Side View