INCRA Mast-R-Lift User Manual

Caution

Advertising

Fig. 5 Install Magna-LOCK ring insert

Fig. 6 Adjust ring flush with plate

Step 2. Adjust ring levelers.

With the ring insert in place, insert the 3/32” hex key into
the four adjustment holes, and adjust as needed to level
the insert flush with the top surface of the plate, Fig. 6.

Note alignment between

insert and plate

3/32” hex key

CAUTION:

Always keep hands safely clear of the

router bit when installing or changing ring inserts.

Step 1. Install Magna-LOCK Ring Insert.

Orient the ring insert relative to the router plate as shown in
Fig. 5 and Fig. 6, then lower into the plate recess. The (4)
rare earth magnets are extremely powerful, and the ring
insert will SNAP into place.
TIP: The insert is keyed to fit only one way. If it doesn’t
align on the first try, flip it over and try again.

To remove the ring insert,
slide the 3/32” hex key
under the access hole,
and lift up, Fig 6A.
DO NOT push downward
on the hex key to remove
the insert, because this
can mar the surface of the
router plate. Lift upwards
instead.

Fig. 6A

Second: Lift UP
to remove insert

from plate

First: Slide 3/32”
hex key under plate

through access hole

Adjustment hole (4)

INCRA Special Edition Mast-R-Lift Manufactured by JessEm

Your new Mast-R-Lift is a Special Edition Model manufactured to INCRA’s custom

specifications by JessEm Tool Company. Here are the special features that are included:

1. Incorporates INCRA’s new 5-ring solid steel MagnaLOCK Ring Insert System in place of the

1-ring Tab-Loc ring insert system included with the standard model.

2. Incorporates INCRA’s new CamLOCK plate locking system.
3. Incorporates INCRA’s new Dual Plate Leveling System that works in all INCRA Router Tables, as

well as most other router tables designed for 9 1/4” by 11 3/4” router plate inserts.

Please read the instructions below for complete details on how to use all of these special features.

MagnaLOCK Ring Insert System: