Intelix DIGI-P122 - Manual (Page 8)

DIGI-P122 / DIGI-P123 Installation Guide
IR Remote
The included IR remote performs all of the functions available on the front
panel of the DIGI-P122/P123, and also allows acces to the setup menu.
Installation Instructions
Shelf Mounting Instructions
Attach the supplied rubber feet to the bottom of the unit.
Rack Mounting Instructions
The DIGI-P122/123 requires one rack unit (1 RU) of space. At least 2 inches of free air space is
required on both sides of the DIGI-P122/123 for proper side ventilation. Avoid mounting the unit
near a power amplifier or any other source of significant heat. It is recommended that you leave
an empty rack space above and below the DIGI-P122/123 for additional cooling.
Twisted Pair Output (DIGI-P123)
The DIGI-P123 includes an HDBaseT Lite extender
output. When used in conjunction with compatible
HDBaseT receivers (see Tech Specs), the scaled signal
may be transmitted up to 70m (230’) away. Additionally,
the user may connect via RS232 to the HDBaseT receiver,
and control the DIGI-P123. Connection should be made
using Cat6 unshielded or shielded cable. Please
terminate both ends using EIA/TIA-568B crimp pattern,
as shown in this diagram.
8