Intelix DIGI-P122 - Manual (Page 9)

DIGI-P122 / DIGI-P123 Installation Guide
Front Panel and IR Remote Operation
Basic Switching
To select an input from the front panel:
1. Press the Input Type button for the input you wish to select (HDMI, VGA, VIDEO)
2. Press the Input Channel button for input you wish to select (1,2,3,4)
To select an input from the IR remote:
1. Point the IR remote at the IR window on the front panel of the DIGI-P122/123
2. Press the Source Select button on the remote that corresponds to the input you wish to
select. There is a button for each input, regardless of type (HDMI, VGA, VIDEO)
Output Resolution
To change the output resolution from the front panel:
1. Press the Output Resolution button to cycle through output resolutions. The selected
resolution will be indicated by the LEDs to the right of the button.
2. Once you have selected the output resolution, it will take 3-5 seconds for the scaler to
perform the function. During this time you may see the picture flash, this is normal.
To change the output resolution from IR remote:
1. Point the IR remote at the IR window on the front panel of the DIGI-P122/123.
2. Press the Output Resolution button on the remote that corresponds to the resolution you
desire. There is a button for each output resolution.
3. Once you have selected the output resolution, it will take 3-5 seconds for the scaler to
perform the function. During this time you may see the picture flash, this is normal.
Volume and Mute
To change the volume of the MIC or LINE audio from the front panel:
1. Press the arrow up or down to raise or lower the volume, respectively. To make a large
change, you can press and hold the button until it reaches an appropriate level.
CAUTION: Increasing volume level too much can cause distortion or feedback, damage
speakers, and/or cause hearing loss.
To change the mute status of the MIC or LINE audio from the front panel:
1. Press the MUTE button that corresponds to the MIC or LINE audio you wish to mute.
2. To cancel the mute, you can press the MUTE button again, or press the arrow UP or
DOWN buttons.
9