Jabra PRO 920 User Manual - Manual (Page 26)

27
english
3. Undock the headset and dock in the new base to copy the settings to the
new base. the headset LeD will flash 5 times to indicate the settings are
being copied, and then will turn solid white when successfully copied to the
new base.
4. to copy the settings to multiple bases, repeat step 3.
5. When finished copying settings, redock the headset with the original base
(primary base), or press and hold the headset mute button until the headset
LeD flashes and then release.
7.9 FORCED PAIRING (PAIRING A NEW PRImARY HEADSET)
It is possible to force the Jabra PRO 920 to pair with a new headset, even when
it is currently paired with another headset.
1. Dock the new headset in the base.
2. Press the multi-function for 1-2 seconds. the headset LeD will begin to flash.
Forced pairing will take between 10 seconds - 2 minutes.
3. When paired successfully, the battery indicator will turn green (or red if the
headset battery is low).
7.10 UPDATE FIRmWARE AND HEADSET SETTINGS (SERVICE CABLE)
It is possible to update the Jabra PRO 920 firmware and headset settings (via
Jabra Control Center) by connecting the Jabra PRO 920 to a PC using the
service cable (optional accessory).
1. Disconnect the Jabra PRO 920 from power.
2. Connect the Jabra PRO 920 to any available Usb port on the PC using the
service cable (optional accessory).
3. Connect the Jabra PRO 920 to power, and wait for the headset indicator to
turn green.
When connected successfully the Jabra 920 base is put into firmware update
mode. It is now possible to update firmware and configure headset settings
using Jabra Control Center (a component of Jabra PC suite). Jabra PC suite can
be downloaded from www.jabra.com/setup.
nOtE: to exit firmware update mode, disconnect the service cable and unplug
the Jabra PRO 920 from power to reboot.