B&K AV2600 - Manual (Page 13)

10
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
No sound (‘on’ LED
not illuminated) 1. Power cord not plugged in.
2. Power off at AC source.
3. AC power inlet fuse blown or faulty
1. Reconnect power cord.
2. Check AC switch or fuse
3. Check for shorts or overloading
No sound on some
or all selected
channels (‘on’ LED
illuminated) 1. Speaker leads loose or faulty
2. Line stage to amp cables loose or
faulty
3. Source to line stage cables loose
or faulty
4. Line stage or source not correctly
selected
1. Tighten, repair or replace cable
2. Tighten, repair or replace cable
3. Tighten, repair or replace cable
4. Check all switch settings
Sound lacks
direction, bass
weak 1. Speakers connected out of phase 1. Check all connections making sure that
cables are connected (+) to (+) and (-) to (-)
Loud hum or buzz
on one or more
channels 1. Poor ground connection in inter-
connect cables
1. Check all connectors and repair as
necessary
Channel sounds
distorted and low
output 1. Blown rail fuse 1. Replace blown rail fuse inside amplifier.
* *Note: If unit continues to blow power inlet fuses, DO NOT USE A HIGHER RATED
FUSE , please contact customer service to have the unit serviced.
CARE AND CLEANING
Under normal use, the amplifier will not require any special care. Clean the exterior of the unit by wiping it with a
damp cloth to remove any dirt or dust that accumulates. Do not let any liquid enter the amplifier through its vents
or top cover. It is recommended that the connectors on the rear panel be cleaned annually using isopropyl
alcohol.