Jabra EXTREME2 - Manual (Page 8)

7
english
Jabra EXTrEME2
tURnInG YoUR HeADset on AnD oFF
- Slide the on/off button forward on the side of the headset to
turn on the headset . The LED will flash green for a second when
the headset is on .
- Slide the on/off button backward to turn off the headset
pAIRInG It WItH YoUR pHone
Headsets are connected to phones using a procedure called
‘pairing’ . by following a few simple steps, a phone can be paired
with a headset in a matter of minutes .
as described in the section Jabra VOICE GUIDaNCE above the
pairing process is supported by voice prompts .
1. Put the headset in pairing mode
- When you turn on your Jabra EXTrEME2 for the first time, the
headset will automatically start up in pairing mode – i .e . it is
discoverable for your phone . When the headset is in pairing
mode the LED is flashing blue .
2. Set your Bluetooth® phone to ‘discover’ the Jabra
EXTREME2
- Follow your phone’s instruction guide . First make sure that
bluetooth® is activated on your mobile phone . Then set your
phone to discover the headset . This usually involves going
to a ‘setup,’ ‘connect’ or ‘bluetooth®’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a bluetooth® device .*
3. Your phone will find the Jabra EXTREME2
- Your phone will find the headset under name “Jabra
EXTrEME2” . Your phone then asks if you want to pair with the
headset . accept by pressing ‘Yes’ or ‘OK’ on the phone and
confirm with the passkey or pIN = 0000 (4 zeros) . Your phone
will confirm when pairing is complete .
* phone dependent